User Feedback :: dsl 3.0 rc problems discuss

ok it ran smooth but noticed that it occupies the cpu %100. and i think that is due fluxbox..

hope some one will figure out what the problem is , i had the same thing when i used the fluxbox 0.9.11 or somthing like that ..

so i guess it is a fluxbox problem.

any suggestions and openions.

would u guys just take that part and use the same fluxbox used in dsl 2.4.. it is simple and greate.

peace

There has been no change to Fluxbox in DSL since 2.4, as far as i know, and no change to the fluxbox version in perhaps the whole history of DSL.
In addition to this, your logic is flawed. If there is trouble, and you change one variable and the trouble remains, how does that mean the trouble is caused by that one variable? If anything, it says that variable as likely NOT the problem.

ok,

for some reason after start up dsl 3.0rc will keep the cpu used %100 ..

r u really going to put out dsl3.0 with this problem.

does any one else notice that torsomo's cpu usage is %100 all the time after startup of dsl 3.0rc or is it just my case?

on dsl 2.4 and prev there is no problems at all.

peace

Did you open a terminal and run top to see what process was using the cpu? I had the same problem before with one of the 2.4 rc's. It has since not happend again in the release or the 3.0 line. Besides 3.0 is in testing and not meant to be perfect at this time, it will have a few problems here and there, which hopefully will be discovered and worked out before release. 2.4 is the released version if you want a stable system.

my cpu runs at zero percent without any apps running.

torp

Next Page...
original here.