The Testing Area :: December Extensions



thanks juanito..

i have a partial success...i can mount and copy but when finish, the next time when i ntfsmount said that its necessary to check in windows...and stop the mount..

who is "sync" command ....

its necesary to sudo modprobe and sudo mkdir every time ?

It can be the possibility to make a lua or script to ntfsmount device and mount point when load the uci..? to add to tools in dsl ...

and the last where are you from...?
Quote (stupid_idiot @ Dec. 20 2007,09:53)
There is a broken row in the table on the MyDSL Testing page.

Hi Robert,

There's another one on the Apps page as well... there's only one 'o' in yellow (yelloow.gif).

Robert, another triviality... do you control the messages that scroll up on bootup?  There's a message that's associated to nodma that has two letter L in the word acceleration.  I'll get it from my dmesg when I run the laptop next time and post the entire phrase if it helps.
Quote
the next time when i ntfsmount said that its necessary to check in windows...and stop the mount..

- I think that when a "foreign" device writes to a windows partition, the chkdsk bit is set and perhaps you cannot write again without performing chkdsk. Maybe one of the other ntfsprogs applets can take care of this?

Quote
who is "sync" command ....

- this empties the disk cache - i.e. it makes sure all of the data is written to disk..

Quote
its necesary to sudo modprobe and sudo mkdir every time ?

- not in the same dsl session, no. After rebooting you will need to repeat these two commands.

Quote
It can be the possibility to make a lua or script to ntfsmount device and mount point when load the uci..? to add to tools in dsl ...

- the problem is the script would have to prompt for the device name to mount which is beyond my scripting abilities...
Quote (john.martzouco @ Dec. 22 2007,04:57)
Quote (stupid_idiot @ Dec. 20 2007,09:53)
There is a broken row in the table on the MyDSL Testing page.

Hi Robert,

There's another one on the Apps page as well... there's only one 'o' in yellow (yelloow.gif).

Robert, another triviality... do you control the messages that scroll up on bootup?  There's a message that's associated to nodma that has two letter L in the word acceleration.  I'll get it from my dmesg when I run the laptop next time and post the entire phrase if it helps.

Found the two typos. Fixed. Thanks.
there's something i noticed about my wm extension mlvwm.uci.
the /opt/.mydsl_menu/mlvwm dir is not removed when unmounting
the uci.
is this intentional? or have i made a boo boo?
(dsl 4.2rc1)
Next Page...
original here.