Release Candidates :: DSL v4.3 RC2

Quote (JohnJS @ April 01 2008,19:27)

Quote (roberts @ April 01 2008,21:11)

Quote (roberts @ April 01 2008,16:18)

Quote (JohnJS @ April 01 2008,12:54)

With 4.3RC1 unable to use cd burner to burn 4.3RC2.

-scanbus gives "no such file or directory. Cannot open '/dev/pg*' and 'cannot open or use SCSI driver'.

Release notes for 4.3RC1 said something about "dropped scsi modules...".

downloaded scsi.tgz but no help.

Thanks for reporting. I will get that pg back in iso.

It is not pg.o.

It is sg.o and sg.o is in scsi.tgz.

The error message is confusing but I have tested sg.o and it works.

unpacked scsi.tgz and extracted sg.o.

Now where do I place it?.

Sorry if this is a totally newbie question.

The easy way is to make a modules directory under your mydsl directory and copy there so you end up with mydsl/modules/sg.o

Then reboot and module will be auto loaded just like an extension.
This will only be necessary in the short term as this module will be back in the next cut of DSL v4.3.

Thanks roberts.

Wish you the best re your medical issue.

In case of frugal upgrade there is no reason to ask boot options and mydsl partition; and are minirt24.gz and linux24 files upgraded in case is needed?

During printer setup the user is not asked to save the printer setting, only when u close dsl, while network setting are immediately saved in the system, there is no need to wait the shutdown.

sorry again for my poor english, and good luck for your health Robert.

legalize cannabis, coke..

Quote

In case of frugal upgrade there is no reason to ask boot options and mydsl partition

I suppose you could grab it from showbootcodes/cmdline

Quote

and are minirt24.gz and linux24 files upgraded in case is needed?

Afaik they are not copied over - typically they are always the same within the same 'branch' release.

minirt24.gz changed in 4.3RC1, for the smaller, in case you didn't upgrade it..

Next Page...
original here.