Networking :: netgear USB wg111t

Ok so just did fresh install of ver 2.1, and got few more bits of info, i did try iwconfig from the control panel as I think you meant doobit, but it just said no connection thanks for the input though, also tryed ver 2.1 with ndiswrapper and got driver loaded hardware present, with one driver and just driver present with the other, (all info says load both of um), which was better than i had before, but nothing else, well gunna crash out later.

Oh I have never seen the LED light up in any linux yet, its dead all the time, thanks later

dsl@box:~$ sudo /opt/madwifi_setup.sh
Warning: loading /lib/modules/2.4.31/net/ath_hal.o will taint the kernel: non-GPL license - Proprietary
See http://www.tux.org/lkml/#export-tainted for information about tainted modules
Module ath_hal loaded, with warnings
wlanconfig: ioctl: No such device
dsl@box:~$

dsl@box:~$ iwconfig ath0
ath0 No such device

dsl@box:~$ iwlist ath0 scan
ath0 Failed to read scan data : No such device

Well i have gone back to ndswrapper, can get hardware pesent,dreiver present, but that still is all i get, no sign of any new network device, and i still havn't seen the light come on in linux, I have done alot more googling, many people are sying that for early versions of ndiswrapper, you need to run "load_fw_ar5523 for loading ar5523 firmware file for Atheros USB devices", does any one know aythng more about this, good luck later

original here.