Joined: Jan. 2009
||Posted: April 20 2009,21:17
I have a PI 166Mhz desktop I want to revive with DSL, but since my graphics card takes up my PCI slot, I only have ISA slots remaining. I have a 3com Ethernet III (3C509B_TP0) ISA card installed.
When I boot, DSL detects both an eth0 and an eth1 controller and backgrounds them (even though there is no other on-board ethernet). Attempts to configure either eth0 or eth1 with auto DCHP fails.
When I switch out this card, and install a PCI ethernet controller, only one card (eth0) is detected and the internet is easily accessible.
I have trolled a few forum posts and while the Ethernet III has shown some problems, none mentioned having two ethernet controllers detected.
Is there a simple boot cheatcode that I am missing, or will configuring this ISA card require a more in-depth solution?
Thanks for any assistance...
Light and Sound make Waves