Usb Cdrom boot problem!!!Forum: User Feedback Topic: Usb Cdrom boot problem!!! started by: m4sterguru Posted by m4sterguru on May 08 2006,09:46
hi all, i have an ibm x20, but no docking station, and i have to use an external usb cdrom. When i try to boot, i have a problem, it apear the boot logon of dsl, then i press enter, and it boot, but after 5 seconds it says that doesn't found any image. The problem is that knoppix boot doesn't recognize and don't mount the cdrom... i tried everything... cheat codes ... usb boot with pen..."my bios doesn't support usb boot, and i don't have a folppy disk "... soo no much left to do.... the last thing i tried it was getting the hard disk out then with other i used an usb disk, i plugged and made an hd install to it, then i put on the laptop, but grub just freeze... soo if anyone have an idea, plz fell free to help me!!!!!
Posted by lwmxynedtodth on May 08 2006,18:01
buy a floppy and write the floppy image on it, providing here:< http://www.damnsmalllinux.org/download.html > the wiki should help you further on booting from a floppy. I do not know if the external cdrom is recognized. Posted by m4sterguru on May 17 2006,17:38
need help!!! plz, does anyone know what to do??
Posted by ZoOp on May 17 2006,18:54
Hi, there are a lot of issues in your message, and I am not able to answer to all, but I shall try to help you a bit: a. CD-ROM: If your CD-ROM has been recognized, i.e. if you see the logo of DSL, your are OK; it means that your computer can run the CD-ROM, and normally, it runs the CD until the end, when x should starts; but you say: it hangs after showing you the DSL prompt; so, you can try to boot in modus 'dsl 2' (please, browse the forum in order to know why); if nothing helps, there is probably a problem with your CD, not your device, but the disc; you may try to burn another one and retry; b. install on disk: it could be the solution; make a frugal install on your disk again; please, at boot prompt use dsl init 2 and then cfdisk in order to format your disk and partition it to have a brand new install; I usually use 3 partitions with 50 MB on hda1 (your first one), some space on hda5 (or 6, or 7, depending on your configuration) and a swap (twice the size of your RAM if you are under 500-700 MB Ram); once partitioned and correctly formated (= it can take two three reboots in order to format your hd properly if you have old materials), run the CD-ROM and install from the mydsl menu; choose frugal install (f.ex. with Grub which is in my opinion easier to configure); restart and you should ready to go; c. grub hangs: there is a lot of possible issues regarding this; when you use dsl 2.4 RC1 or RC2, it is possible that you have such a problem as I have one also related to grub (impossible to get the boot logo of the cd on my laptop, grub starts faster). Hope it will help you. yours z Posted by pr0f3550r on May 18 2006,18:21
Because you are using a second cd drive maybe you could try adding the option:dsl fromhd=/dev/scd2
But then it depends, it could be sdb, sdc, try all of them. |