bootlocal.sh not working during USB booting.


Forum: USB booting
Topic: bootlocal.sh not working during USB booting.
started by: iunknown

Posted by iunknown on Dec. 15 2004,01:56
I want to config the static IP in the USB system via giving ifconfig command in /opt/bootlocal.sh, but seems not working.
The command is as the following:
Code Sample

ifconfig eth0 ip 192.168.0.15 netmask 255.255.255.0 up
route add default gw 192.168.0.1
echo "nameserver actual_ip_goes_here" > /etc/resolv.conf


The whole command scripts in bootlocal.sh seems not working. Is there anthing I missed? Or is there any other way to auto add the static IP during booting?

Posted by roberts on Dec. 15 2004,02:31
Oh bootlocal.sh works just fine booting from usb.
I assume that you are using the backup method to save your bootlocal.sh.
For a simple test, I just did this.  Try the following.

Add this line to your bootlocal.sh

touch /home/dsl/this_is_a_test

If you have not made a backup, then be sure to do that, From control panel click on backup/restore then enter sda1 then click on backup.

When completed, you should see the backup.tar.gz if you do a ls /cdrom
Then shutdown, upon reboot your backup.tar.gz will be restores and the opt.bootlocal.sh will execute and finally you should see a zero byte file
/home/dsl/this_is_a_test

Now your static ip may be another issue. However, I do set my static ip via a usb boot as well

Posted by iunknown on Dec. 15 2004,03:43
Hi roberts,

I got the this_is_a_test file, but still have no correct static IP . The bootlocal.sh is working, the ifconfig is not working.

I can't get the correct static IP till disable the DHCP during booting. But I don't know the reason.

Powered by Ikonboard 3.1.2a
Ikonboard © 2001 Jarvis Entertainment Group, Inc.