Help!

Forum: Networking
Topic: Help!
started by: kwjake

---

Posted by kwjake on June 06 2005,19:40

< Link >

Any input?

---

Posted by Guest on June 06 2005,19:59

After you boot DSL, open an XTerminal and type "ps ax".  Check the output to see an item that says "pump".  If you see this, type "sudo pump -k", and then "sudo pump -i eth0".  Then type "sudo pump -s" and tell us what you see.

---

Posted by kwjake on June 06 2005,20:12

Yea, I saw pump, but after typing in sudo pump -s, I got an "operation failed".

---

Posted by Guest on June 06 2005,20:50

Then you may have a cable or connection problem.

---

Posted by kwjake on June 07 2005,04:19

Can't be, I have used the cable before and I am on the same router right now.

---

Posted by Guest on June 07 2005,15:54

But is this the same computer?  Note that small-form-factor PCI network cards are notorious for pretending that it is plugged-in when in fact it is not.  Yes you see an indicator light, but that does not mean it is plugged-in properly.  I should know; it took me three weeks to find out on mine.

---

Posted by kwjake on June 09 2005,04:34

Here is a recapitulation of all that I have done:

OS: Damn small linux
CPU: 133mhz
HD: 1GB
RAM: ?
Ethernet Card: < JAHT JN-110R PCI >

lsmod:




dmesg:




ifconfig:

Code Sample

lo  Link encap:Local Loopback      inet addr:127.0.0.1 Mask:255.0.0.0      UP LOOPBACK RUNNING MTU:16436 Metric:1      RX packets:2 errors:0 dropped:0 overruns:0 Frame:0      TX packets:2 errors:0 dropped:0 overruns:0 Carrier:0      collisions:0 txqueueln:0      RX bytes:100 (100.0 B) TX bytes:100 (100.0 B) eth0  Link encap:Ethernet HWaddr 00:0E:2E:3A:B2:0E        BRODCAST MULTICAST MTU:1500 Metric:1        RX packets:2 errors:0 dropped:0 overruns:0 Frame:0        TX packets:2 errors:0 dropped:0 overruns:0 Carrier:0        collisions:0 txqueueln:0        RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)        Interrupt:10 Base address:0xff00

I downloaded and compiled dhcpcd, then:

Code Sample

modprobe 8139too dhcpcd eth0

I also tried:

Code Sample

dhcpcd -HD eth0

and

Code Sample

pump

Took awhile, but it didn't work. No output. Still no net.

---

Posted by kwjake on June 09 2005,05:09

NM, problem solved.

---

Posted by Guest on June 09 2005,16:00

So what was the solution?

---

Posted by kwjake on June 09 2005,16:05

I un-plugged it and plugged it into a new pci slot. Maybe the first slot had dirt in it or something .

---