huti
Group: Members
Posts: 4
Joined: Feb. 2005 |
 |
Posted: June 09 2005,17:16 |
 |
Similar problem as above: 3c509, modem LAN led on, TxRx led flashes, but no connection. Running DSL 0.9.3,
modem is VisionNet - ADSL 204.
Details below::
root@box:~# modprobe 3c509
root@box:~# netcardconfig - Use DHCP broadcast? <Yes>
Sending DHCP broadcast from device eth0Operation failed.
(LAN led lit and Tx/RX led flickered periodically)
Hit return to exit. (LAN led off)
root@box:~# ps ax
PID Uid VmSize Stat Command
1 root 76 S init [5]
..
278 root 1880 S /bin/bash
326 root 668 S pump -i eth0
329 dsl 3132 S beaver
341 root 708 R ps ax
root@box:~# pump -k
root@box:~# ps ax
PID Uid VmSize Stat Command
1 root 76 S init [5]
...
278 root 1880 S /bin/bash
329 dsl 3132 S beaver
343 root 708 R ps ax
root@box:~# netcardconfig -
Use DHCP broadcast? <No>
Please enter IP Address for eth0 192.168.1.4
Please enter Network Mask for eth0 255.255.255.0
Please enter Broadcast Address for eth0 192.168.1.254
Please enter Default Gateway 192.168.1.1
Please enter Nameserver(s) 216.150.100.1 216.150.100.2
ifconfig eth0 192.168.1.4 netmask 255.255.255.0 broadcast 192.168.1.254 up
route add default gw 192.168.1.1
auto lo eth0
Setting Nameserver in /etc/resolv.conf to 216.150.100.1
Adding Nameserver to /etc/resolv.conf: 216.150.100.2
Done. <LAN led lite)
root@box:~# ps ax - no pump entry
root@box:~# man ps
blank box except for "looking up host" at bottom left,
modem Tx/Rx led flashes periodically,
after 3 (?) minutes text box appears...
HOST NOT FOUND
[CANCEL]
pressed Enter and this was displayed:
http://www.mcsr.olemiss.edu/cgi-bin/man-cgi?ps
root@box:~# pump -i eth0
Operation failed. (LAN led is off)
root@box:~#
rebooted, LAN led is off.
root@box:~# modprobe 3c509, LAN led is off.
DSL Control Panel - PPPoE
lqqqqqqqqqqqqqqqqqqu ALL DEVICES FOUND? tqqqqqqqqqqqqqqqqqqk
x I found 1 ethernet device(s):\neth0\n\nAre all your x
x ethernet interfaces listed above?\n(If No, modconf x
x will be started so you can load the card drivers x
x manually).\n\nOr press Ctrl-C to abort here. x
<Yes>
LAN led is on here OR
lqqqqqqqqqqqqqqqqqqqu SCANNING DEVICE tqqqqqqqqqqqqqqqqqqqqk
x Looking for PPPoE Access Concentrator on eth0... x
LAN led is on here?
lqqqqqqqqqqqqqqqqqqqqu NOT CONNECTED tqqqqqqqqqqqqqqqqqqqqqk
x Sorry, I scanned 1 interface(s), but the Access x
x Concentrator of your provider did not respond. Please x
x check your network and modem cables. Another reason x
x for the scan failure may also be another running pppoe x
x process which controls the modem. x
LAN led is still on
root@box:~# ps ax - no 'pump' entry
root@box:~# pump -i eth0 - (LAN led is on, Tx/Rx led flashes periodically
Operation failed. (LAN led is off)
root@box:~# ps ax
PID Uid VmSize Stat Command
1 root 76 S init [5]
...
398 root 1880 S /bin/bash
536 root 668 S pump -i eth0
562 root 708 R ps ax
root@box:~# pon (no visible effect, LAN led is still off)
root@box:~# ifconfig
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:2 errors:0 dropped:0 overruns:0 frame:0
TX packets:2 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:100 (100.0 B) TX bytes:100 (100.0 B)
ppp0 Link encap:Point-Point Protocol
inet addr:216.150.105.113 P-t-P:216.150.105.65 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1500 Metric:1
RX packets:3718 errors:84 dropped:0 overruns:0 frame:0
TX packets:4154 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:3
RX bytes:3747593 (3.5 MiB) TX bytes:378886 (370.0 KiB)
root@box:~#
|
.
DSL Market ,
Great VPS hosting provided by Tektonic
