dave mckinley
Unregistered
|
|
Posted: Mar. 07 2006,23:14 |
|
Quote (beakmyn @ Mar. 02 2006,09:45) | Downloaded and burned a nice fresh 2.2b image to CD. Booted off the CD without a hitch, as always. Perfomed a pendrive USB install, When I boot off the pendrive Autoconfigure progress bar goes all the way to the right side of the screen and then eventually the screen fills with errors to the effect of :
Error reading... ELF section headers and cp reading \KNOPPIX\OPT : Input/Output error
I've tried formatting the USB and letting it repartition etc with the same outcome everytime. Booted using the 2.1 version created a USB pendrive install and booted off it without any problems.
Created an iso of the 2.2b CD and its MD5 matches the MD5 on download page.
Something isn't quite right. |
Just tried 2.2 and 2.2b, burnt CD's, both boot fine on desktop. Created USB pendrive that previously ran 2.1 for laptop. Neither will run. No error during Pendrive or CD creation.
Error says essentially can't find /lib files for modpobe---lots of errors then boots up. Orinoco card in PCMCIA slot is not seen, IWCONFIG says nothing there. Control panel PCMCIA "utility" shows nothing plugged in slot since no software to "size" or access it.
Went through this enough times trying different things, something is missing from this upgrade to 2.2.
I booted the desktop also using a boot floppy and the pendrive, similar problem--no lib files, can't probe the hardware, can't find eth0. Both of these machines always worked before on the pendrives---version 2.1, 2.0, etc.
|